METZGER/McGUIRE Products

Available in 12 colours to best camouflage floor surface pitting and surface imperfections

Rapid-set formula allows for quick access to floor areas and grinding as early as 40 minutes after application (@70°) or 20 minutes with Accelerator Pack

Low viscosity allows for penetration into very small surface pits and imperfections

Yields a smoother, denser floor surface which can aid in achieving higher gloss and DOI values

SRG is designed primarily for fine grouting and not for use in repairing surface defects larger than ½” unless modified with sand aggregate or Rapid Set® TRU® and TRU® PC

Depending upon surface conditions and/or environmental conditions, more than one coat of product may be required

SRG may exhibit slight colour change or shifting if exposed to UV emitting lighting sources

Use only in well-ventilated areas

SRG will exhibit a moisture reaction on damp or wet surfaces; repair area should be dry

SRG can also be mixed with sand aggregate to create a repair mortar suitable for joints, cracks, and larger surface defects

Apply material generously on the floor and work into the surface using a metal smoother, rigid-edged trowel or screeding device. Monitor surface for air holes resulting from entrapped air and re-apply as needed. In some cases, more than one coat will be required for best results. If two coats are desired, first coat should be ground off prior to installing a second coat

When sequencing product installation as part of a concrete grinding/polishing process, install prior to your last metal or transitional tooling step. Use the least aggressive tooling which successfully removes the product and avoids opening more air holes/voids in the floor surface

SRG, when used as a repair mortar, should be allowed to cure for 2 hours or more prior to removing overfill material. Overfill can be removed with a diamond cup wheel or similar. If pin holes are present at the surface, fine grouting with additional SRG neat may be desired