METZGER/McGUIRE Products

Spal-Pro 2000 is Rated “Heavy-Duty”: Unlike other flexible polyureas, it will not deflect under loads, allowing joint edges to deteriorate (spall)

“Rapid Setting”: You can expose Spal-Pro 2000 to moderate traffic loads in fifteen (15) minutes and full, heavy traffic in thirty (30) minutes

“All Temperatures”: It can be used in coolers/freezers down to minus 20˚F (-29˚C), in ambient settings or at temperatures up to 120˚F (49˚C), all with equally successful results

“Superior Formulation”: You get consistent cure and quality in all environments; no uncured strips, no soft, hard spots as with some other polyureas

Comes with a “Legacy”: For 30+ years, Metzger/McGuire has been the unequaled leader in floor joint protection technology and technical/field support

Spal-Pro 2000’s expansion capability is limited due to its supportive hardness and compressive strength (see section 14)

Intended for interior use. It is not UV resistant. Sunlight or lights emitting UV rays may cause discolouration

Not recommended for use under VCT/seamless floor systems

Spal-Pro 2000 contains no VOC’s and is acceptable for use in floors subject to USDA/FDA and CFIA inspection and regulation and is compliant with LEED® Green Building Standards. Use only in well ventilated areas

Fill repair, taking care not to entrap large air bubbles. The recommended procedure is to overfill (crown) and allow to cure. Crown can later be razored-off, leaving top of filler flush with floor surface