Call Us Today: (403) 569-6879

METZGER/McGUIRE Products

Joint Repair

Armor-Hard Primer

Armor-Hard Primer

Epoxy Primer For Use With Armor-Hard Product Line
Product Quantity 0.75 gal kit
Colours Thin Amber Liquid
Working Time 20 Minutes
Dry Time 25 Minutes Gel Time | 6 Hours TF
SF Or LF 100-300 SF
Area Or Depth /gal
Floor Or Wall Floors
Interior or Exterior Interior
TF Tack Free
RC Recoat
FT Foot Traffic
LT Light Traffic
DT Dry Through
FC Full Cure

  • 100% Solids

  • Excellent Wear & Impact Resistance

  • Environmentally Friendly

  • USDA/FDA/CFIA Acceptable

  • Oils, grease, fats, waxes, or other contaminants must be removed prior to roughening the concrete. To achieve maximum adhesion, the substrate should be free of all loose and foreign materials and should be roughened to provide a coarse profile by either shot blasting or shaving/planing the concrete floor surface

  • NEW CONCRETE SHOULD HAVE A MINIMUM CURE OF 30 DAYS PRIOR TO THE APPLICATION OF ANY EPOXY

  • Blend thoroughly using a mixing paddle and slow speed hand drill for 3 minutes. Mix at slow speeds (less than 850 rpm) to avoid air entrainment. DO NOT apply Armor-Hard PRIMER over standing water. Damp or dry concrete is acceptable

  • Armor-Hard PRIMER can be applied by brush or short nap roller. Do not thin primer! Do not over-apply or allow to puddle. Armor-Hard products can be applied to the ArmorHard PRIMER immediately or while primer is still tacky. If primer is no longer tacky, it is necessary to mechanically abrade the surface and re-apply primer prior to installing Armor-Hard products