Call Us Today: (403) 569-6879

LabSurface Products

Polyaspartics

LABSURFACE LABSHIELD Eco

LABSHIELD ECO+ 100%

Polyaspartic Floor Coating System
Product Quantity 3 gal
Colours Clear (Grey, Tan, Black, & White Available At Request)
Working Time 25 Minutes
Dry Time 4.5 Hours TF | 4.5 Hours RC | 8 Hours DT | 12 Hours FT | 24 Hours LT | 2 Weeks FC
SF Or LF 399 SF
Area Or Depth 12 mils/gal
Floor Or Wall Floors
Interior or Exterior Interior & Exterior
Shore Hardness D60
TF Tack Free
RC Recoat
FT Foot Traffic
LT Light Traffic
DT Dry Through
FC Full Cure
VT Vehicular Traffic
FUT Full Traffic

  • Solvent-free, no/minimal odour, zero VOC, 100% solids, non-yellowing, easy to install due to low viscosity, long recoat window, high elongation

  • Excellent impact and abrasion resistance

  • 2:1 system with common hardener for the base coat and topcoat; possibility to install base coat and topcoat in a single workday

  • Cures quickly – recommended to obtain best curing at very low temperature levels (below zero Celsius)

  • Possible to install two- or three-coat systems (Same as above)

  • Excellent chemical and mechanical resistance

  • Impermeability / low moisture sensitivity

  • Superior gloss finish

  • High density of the product prevents dirt penetration resulting in low maintenance

  • Potential for LEED eligibility

  • Cannot use Pigment Pods with this product

  • 200 SF @ 8 mils/gal

  • Best results will be obtained between 5oC and 30oC and with a relative humidity of less than 80%. This product will also cure at temperatures well below 5oC Celsius. If a heated floor is installed, ensure that the system is turned off during application and for the full duration of the cure. The product has been designed to adhere to concrete surfaces. Once the surface has been properly prepared, squeegee and back roll the product. It is recommended to apply the product in a multidirectional (north-south, east-west) motion to ensure proper coating thickness