LabSurface Products

Environment friendly (100% solids, VOC-free and no solvent), available in unlimited color range, virtually odor free, self-priming topcoat epoxy (use Epoxy Primer for Heavy Traffic)

Easy application with long pot life and working time (60 minutes)

Can be used for metallic epoxy systems

Superior mechanical and chemical properties suited for the toughest industrial applications

Good elongation and excellent abrasion resistance

High resistance to amine blush and contamination (fish eyes)

Impermeability / low moisture sensitivity

High density of the product prevents dirt penetration resulting in low maintenance post application

Potential for LEED eligibility

200 SF @ 8 mils/gal

Apply only when air and slab temperature is between 16-30oC and the relative humidity of less than 85%. If a heated floor is installed, ensure that the system is turned off during application and for the full duration of the cure. The product has been designed to adhere to concrete surfaces. The LABPOX 30 is self-priming. When used as a base coat, apply with a squeegee in thin coat without back rolling to seal properly the surface, this will help reduce the creation of pin holes. For the second coat, repeat the same steps and back roll the product. It is recommended to apply the product in a multi-directional (northsouth, east-west) motion to ensure proper coating thickness. If there is a significant presence of pinholes after applying the first coat due to the porosity of the concrete, sand and plug the pinholes with epoxy gel. We recommend the application of one base coat and one topcoat for total system thickness of approximately 20 mils for standard systems. For metallic systems, we recommend a thickness level between 30 and 50 mils for the metallic topcoat

Do not recoat without sanding if last coating of the product has been applied for more than 24 hours