Call Us Today: (403) 569-6879

LabSurface Products

Epoxies

LABSURFACE Epoxy Primer

Epoxy Primer

Epoxy
Product Quantity 3 gal
Colours Clear
Working Time 45 Minutes
Dry Time 4 Hours TF | 8 Hours DT | 4-24 Hours RC
SF Or LF 400 SF
Area Or Depth 4 mils
Floor Or Wall Floors
Interior or Exterior Interior
TF Tack Free
RC Recoat
FT Foot Traffic
LT Light Traffic
DT Dry Through
FC Full Cure
VT Vehicular Traffic
FUT Full Traffic

  • Environment friendly with no VOC, 100% solids, minimal odour, fast curing, low viscosity, long working time, excellent penetration and adhesion to concrete

  • Best suited for high traffic applications

  • High resistance to amine blush and contamination (fish eyes)

  • High elongation for optimal impact absorption and better protection when slab movements occur

  • Potential for LEED eligibility

  • 267 SF @ 6 MILS

  • Labsurface’s top coat epoxies will bind to the EPOXY PRIMER withoutsanding if installed within 24 hours

  • Apply only when air and slab temperature is between 16-30oC and the relative humidity of less than 85%. If a heated floor is installed, ensure that the system is turned off during application and for the full duration of the cure. The product has been designed to adhere to concrete surfaces. It is recommended to use only the quantity required to seal the concrete prior to applying an epoxy base and topcoat (LABPOX 30 or LABPOX 40 UV). Apply with a squeegee in a thin coat without back rolling to seal the surface properly. This will also help reduce the creation of pin holes. If there is a significant presence of pinholes due to the porosity of the concrete, sand and plug the pinholes with epoxy gel. A thickness of 4-6 mils is recommended for the EPOXY PRIMER. Coverage rates can vary significantly depending on the concrete’s porosity