Call Us Today: (403) 569-6879

ARDEX Products

Floor Patch



Self-Drying Cement-Based Finish Underlayment
Product Quantity 10 lbs
Colours Grey
Working Time 10 Minutes
Pot Life 15-20 Minutes
Dry Time 15-20 Minutes | Install Flooring
SF Or LF 16.7 SF | 100-300 SF
Area Or Depth 1/4" Thick | Skim Coat
Floor Or Wall Floors
Interior or Exterior Interior
TF Tack Free
RC Recoat
CG Concrete Guard
CD Concrete Dressing
FT Foot Traffic
LT Light Traffic
DT Dry Through
FC Full Cure
HFT Heavy Foot Traffic (Forklift)
VT Vehicular Traffic
FUT Full Traffic
  • ARDEX FEATHER FINISH allows the installation of most types of floor covering in as little as 15 minutes over all types of interior concrete, masonry, wood, terrazzo, and ceramic and quarry tile - as well as properly prepared residues of cutback and other non-water-soluble adhesives on concrete - all without the need for priming or the use of a latex additive. Using this unique technology, flooring installation problems associated with disbonding, crumbling, mold, mildew and staining are eliminated, thus preserving the floor manufacturer’s full product warranty

  • Self-drying, finishing underlayment

  • Provides a smooth surface prior to the installation of floor covering over a variety of substrates

  • A blend of Portland cement and other hydraulic cements

  • Exceptional bond strength

  • Easy to mix and apply

  • Suitable for castor wheels (EN 12 529)

  • Mixes with water only

  • True featheredge

  • Mold and mildew resistant

  • Install on top: Ceramic tile, VCT, sheet vinyl, carpet

  • Install up to 1/2"

  • Recommended Tools: ARDEX T-2 Ring Mixing Paddle, mixing bucket, margin trowel, steel trowel, razor scraper, and a 1/2” (12 mm) heavy-duty drill (min. 650 rpm)

  • ARDEX FEATHER FINISH will bond to some non-porous substrates, such as burnished concrete, terrazzo, and ceramic and quarry tile, without the use of a primer (P-82)

  • INSTALLATION GUIDELINES: After mixing, apply the ARDEX FEATHER FINISH to the substrate with the flat side of a steel trowel to obtain a solid mechanical bond before applying the desired thickness. Apply sufficient pressure to fill all defects and to feather the product onto the subfloor surface

  • See TDS for application guidelines for embossing filler