Call Us Today: (403) 569-6879

ARDEX Products

Floor Patch

CP™

Concrete Patch
Product Quantity 40 lbs
Colours Light Grey
Working Time 30 Minutes
Pot Life 30 Minutes
Dry Time 4 Hours CD | 24 Hours CG | 2 Hours FT
SF Or LF 22.5 SF
Area Or Depth 1/4" Thick
Floor Or Wall Floors & Walls
Interior or Exterior Interior & Exterior
Compressive Strength (PSI) Day28 3600
TF Tack Free
RC Recoat
CG Concrete Guard
CD Concrete Dressing
FT Foot Traffic
LT Light Traffic
DT Dry Through
FC Full Cure
HFT Heavy Foot Traffic (Forklift)
VT Vehicular Traffic
FUT Full Traffic
  • ARDEX CPTM is a trowel-grade, cementitious topping for filling and repairing areas of indoor and outdoor concrete above, on or below grade. Engineered with Portland cement and select high-performance polymers, ARDEX CP readily bonds to concrete surfaces. It is easy to apply, hardens quickly, is freeze-thaw resistant, and produces a surface finish that is suitable for foot and rubber tire traffic. When mixed with water, the result is a creamy, smooth consistency that can be applied by trowel or screed

  • Portland cement-based concrete patch and fill

  • Repair, re-slope and re-form all concrete surfaces

  • Easy to apply and hardens quickly

  • Installs from 1/4” to 1/2” (6 to 12 mm) neat, and up to 2” (5 cm) with aggregate

  • Freeze-thaw resistant

  • Suitable for foot and rubber tire traffic

  • Suitable for commercial and residential applications

  • Do not use in fountains, inside swimming pools or in any areas that will be permanently submerged in water. Not intended for industrial uses such as heavy manufacturing or areas with heavy truck traffic

  • ARDEX CP is not intended for industrial uses such as heavy manufacturing or areas with heavy truck traffic

  • Recommended Tools: Mixing buckets, margin trowel, wood or magnesium float, steel trowel, a mechanical mixing paddle and a 2” heavy-duty drill (12 mm, min. 650 rpm)

  • Use ARDEX CP to fill spalls, gouges, dormant cracks, “birdbaths” and other low areas in existing concrete surfaces, including sidewalks, patios, plazas, courtyards, walkways, driveways, parking garages, pool decks and vertical concrete surfaces. ARDEX CP can also be used to re-form concrete steps and curbs, to create ramps over existing concrete, or to resurface vertical concrete substrates

  • ARDEX CP can be installed from 4” to 2” (6 to 12 mm) neat, and up to 2” (5 cm) with the addition of proper aggregate. For areas thicker than 2” (12 mm), mix ARDEX CP with washed and well-graded 8” to 4” (3 to 6 mm) pea gravel. Mix the ARDEX CP with water first, and then add 1 part by volume of aggregate, mixing until the aggregate is completely coated

  • Do not use sand. If aggregate is wet, reduce the amount of water to avoid over watering. Please note that thicker areas will take longer to set and will reduce the overall coverage